Chapter 7 System Status and Port Statistics
GS2200-8/24 User’s Guide
62
Link This field displays the speed (either 100M for 100Mbps or 1000M for 1000Mbps) and the
duplex (F for full duplex or H for half). It also shows the cable type (Copper or Fiber) for
the combo ports.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port (see
Section 13.1 on page 109 for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
PD (For GS2200-8HP or GS2200-24P only) This field displays whether or not a powered device
(PD) is allowed to receive power from the Switch on this port.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on
the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port has been
up.
Clear Counter Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
Table 7 Status (continued)
LABEL DESCRIPTION
