Chapter 37 Syslog
GS2200-8/24 User’s Guide
289
37.3 Syslog Server Setup
Click Management > Syslog > Syslog Server Setup to view the screen as shown next. Use this
screen to configure a list of external syslog servers.
Figure 191 Management > Syslog > Syslog Server Setup
The following table describes the labels in this screen.
Table 120 Management > Syslog > Syslog Server Setup
LABEL DESCRIPTION
Active Select this check box to have the device send logs to this syslog server. Clear the check
box if you want to create a syslog server entry but not have the device send logs to it (you
can edit the entry later).
Server Address Enter the IP address of the syslog server.
Log Level Select the severity level(s) of the logs that you want the device to send to this syslog
server. The lower the number, the more critical the logs are.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to return the fields to the factory defaults.
Index This is the index number of a syslog server entry. Click this number to edit the entry.
Active This field displays Yes if the device is to send logs to the syslog server. No displays if the
device is not to send logs to the syslog server.
IP Address This field displays the IP address of the syslog server.
Log Level This field displays the severity level of the logs that the device is to send to this syslog
server.
Delete Select an entry’s Delete check box and click Delete to remove the entry.
Cancel Click Cancel to begin configuring this screen afresh.
