Appendix A Product Specifications
V300 User’s Guide
132
Power over Ethernet (PoE) Specifications (V301 Only)
You can use a power over Ethernet injector to power the V301. The injector must comply to IEEE
802.3af.
Wall-mounting Instructions
Complete the following steps to hang your V300 on a wall.
" See Table 39 on page 129 for the size of screws to use and how far apart to
place them.
1 Select a position free of obstructions on a sturdy wall.
2 Drill two holes for the screws.
1 Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
3 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm
between the heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the weight of
the V300 with the connection cables.
5 Align the holes on the back of the V300 with the screws on the wall. Hang the V300 on
the screws.
Table 42 Power over Ethernet Injector Specifications
Power Output 15.4 Watts maximum
Power Current 400 mA maximum
Table 43 Power over Ethernet Injector RJ-45 Port Pin Assignments
PIN NO
RJ-45 SIGNAL
ASSIGNMENT
1 Output Transmit Data +
2 Output Transmit Data -
3 Receive Data +
4 Power +
5 Power +
6 Receive Data -
7 Power -
8 Power -
12345678
