Chapter 8 Status Screens
V300 User’s Guide
70
Device Information
System Name This field displays the V300’s system name. It is used for identification. You
can change this in the Maintenance > System > General screen’s System
Name field.
Firmware Version This field displays the current version of the firmware inside the device. It also
shows the date the firmware version was created. You can change the
firmware version by uploading new firmware in Maintenance > Tools >
Firmware.
IP Address This field displays the current IP address of the V300 on the LAN.
IP Subnet Mask This field displays the current subnet mask on the LAN.
DHCP This field displays what DHCP services the V300 is receiving from the LAN.
Choices are:
Client - The V300 is a DHCP client. It is receiving DHCP services.
None - The V300 is not receiving DHCP services.
You can change this in the Network > Ethernet > Internet Connection
screen.
System Status
System Uptime This field displays how long the V300 has been running since it last started up.
Current Date/
Time
This field displays the current date and time in the V300. You can change this
in Maintenance > System > Time Setting.
CPU Usage This field displays what percentage of the V300’s processing ability is currently
in use. If this nears 100%, the V300 may slow down.
Memory Usage This field displays what percentage of the V300’s memory is currently in use. If
this nears 100%, the V300 may slow down. Some memory is required just to
start the V300 and to run the web configurator. You can reduce the memory
usage by deleting rules in functions such as call forwarding, speed dial entries,
and contact list entries.
Interface Status
Interface This column displays each interface of the V300.
Status This field indicates whether or not the V300 is using the interface.
This field displays Up when the V300 is using the interface and Down when
the V300 is not using the interface.
Rate This displays the port speed and duplex setting. Ethernet port connections can
be in half-duplex or full-duplex mode. Full-duplex refers to a device's ability to
send and receive simultaneously, while half-duplex indicates that traffic can
flow in only one direction at a time. The Ethernet port must use the same
speed or duplex mode setting as the peer Ethernet port in order to connect.
VoIP Status
Account This column displays each SIP account in the V300.
Registration This field displays the current registration status of the SIP account. You have
to register a SIP account with a SIP server to use VoIP.
If the SIP account is already registered with the SIP server,
Click Unregister to delete the SIP account’s registration in the SIP server.
This does not cancel your SIP account, but it deletes the mapping between
your SIP identity and your IP address or domain name.
The second field displays Registered.
If the SIP account is not registered with the SIP server,
Click Register to have the V300 attempt to register the SIP account with
the SIP server.
The second field displays Unregister.
Table 16 Status Screen
LABEL DESCRIPTION
