76
Enhancements
Release K.13.04 Enhancements
Release K.13.04 Enhancements
Release K.13.04 includes the following enhancements.
■ Enhancement (PR_ 0000000081) — The CLI clear module command allows you to remove
module configuration information from the configuration file.
Clear Module Configuration
Overview
Because of the hot-swap capabilities of the modules, when a module is removed from the chassis of
a ProCurve series 5400 switch, the module configuration remains in the configuration file. This
enhancement allows you to remove the module configuration information from the configuration file.
For example:
ProCurve(config)# no module 3
Note
This does not change how hot-swap works.
Operating Notes
The following restrictions apply:
■ The slot being cleared must be empty
■ There was no module present in the slot since the last boot
■ If there was a module present after the switch was booted, the switch will have to be rebooted
before any module (new or same) can be used in the slot.
■ This does not clear the configuration of a module still in use by the switch.
Syntax: [no] module <slot>
Allows removal of the module configuration in the configuration file after the
module has been removed. Enter an integer between 1 and 12 for <slot>.
