Chapter 11 Spanning Tree Protocol
GS2200-48 User’s Guide
111
11.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes
on the Switch. Click Configuration in the Advanced Application > Spanning
Tree Protocol.
Figure 49 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 27 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree or Multiple Spanning Tree. See Section
11.1 on page 105 for background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
