A SERVICE OF

logo

Chapter 15 Link Aggregation
GS2200-48 User’s Guide
135
15.5 Link Aggregation Control Protocol
Click in the Advanced Application > Link Aggregation > Link Aggregation
Setting > LACP to display the screen shown next. See Section 15.2 on page 131
for more information on dynamic link aggregation.
Figure 59 Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 38 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION