Chapter 23 Authentication & Accounting
GS2200-48 User’s Guide
197
23.2.3 Authentication and Accounting Setup
Use this screen to configure authentication and accounting settings on the Switch.
Click on the Auth and Acct Setup link in the Authentication and Accounting
screen to view the screen as shown.
Figure 93 Advanced Application > Auth and Acct > Auth and Acct Setup
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be
shared between the external TACACS+ accounting server and the
Switch. This key is not sent over the network. This key must be the same
on the external TACACS+ accounting server and the Switch.
Delete Check this box if you want to remove an existing TACACS+ accounting
server entry from the Switch. This entry is deleted when you click Apply.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 63 Advanced Application > Auth and Acct > TACACS+ Server Setup
LABEL DESCRIPTION
