Chapter 8 VLAN
GS2200-48 User’s Guide
88
8.6 Subnet Based VLANs
Subnet based VLANs allow you to group traffic into logical VLANs based on the
source IP subnet you specify. When a frame is received on a port, the Switch
checks if a tag is added already and the IP subnet it came from. The untagged
packets from the same IP subnet are then placed in the same subnet based VLAN.
One advantage of using subnet based VLANs is that priority can be assigned to
traffic from the same IP subnet.
For example, an ISP (Internet Service Provider) may divide different types of
services it provides to customers into different IP subnets. Traffic for voice
services is designated for IP subnet 172.16.1.0/24, video for 192.168.1.0/24 and
data for 10.1.1.0/24. The Switch can then be configured to group incoming traffic
based on the source IP subnet of incoming frames.
You can then configure a subnet based VLAN with priority 6 and VID of 100 for
traffic received from IP subnet 172.16.1.0/24 (voice services). You can also have
a subnet based VLAN with priority 5 and VID of 200 for traffic received from IP
subnet 192.168.1.0/24 (video services). Lastly, you can configure VLAN with
priority 3 and VID of 300 for traffic received from IP subnet 10.1.1.0/24 (data
Ingress Check If this check box is selected for a port, the Switch discards incoming
frames for VLANs that do not include this port in its member set.
Clear this check box to disable ingress filtering.
PVID Enter a number between 1and 4094 as the port VLAN ID.
GVRP Select this check box to allow GVRP on this port.
Acceptable
Frame Type
Specify the type of frames allowed on a port. Choices are All, Tag Only
and Untag Only.
Select All from the drop-down list box to accept both untagged or
tagged frames on this port. This is the default setting.
Select Tag Only to accept only tagged frames on this port. All untagged
frames will be dropped.
Select Untag Only to accept only untagged frames on this port.
VLAN Trunking Enable VLAN Trunking on ports connected to other switches or routers
(but not ports directly connected to end users) to allow frames
belonging to unknown VLAN groups to pass through the Switch.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 19 Advanced Application > VLAN > VLAN Port Setting (continued)
LABEL DESCRIPTION
