A SERVICE OF

logo

Chapter 6 System Status and Port Statistics
GS2200-48 User’s Guide
58
6.2 Port Status Summary
To view the port statistics, click Status in all web configurator screens to display
the Status screen as shown next.
Figure 22 Status
The following table describes the labels in this screen.
Table 8 Status
LABEL DESCRIPTION
Port This identifies the Ethernet port. Click a port number to display the Port
Details screen (refer to Figure 23 on page 59).
Name This is the name you assigned to this port in the Basic Setting > Port
Setup screen.
Link This field displays the speed (either 10M for 10 Mbps, 100M for 100
Mbps and 1000M for 1000 Mbps) and the duplex (F for full duplex or H
for half). It also shows the cable type (Copper or Fiber) for the combo
ports.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP
state of the port. (see Section 11.1.3 on page 107 for more information).
If STP is disabled, this field displays FORWARDING if the link is up,
otherwise, it displays STOP.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has
been enabled on the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.