A SERVICE OF

logo

Chapter 15 Link Aggregation
GS2200-48 User’s Guide
137
1 Make your physical connections - make sure that the ports that you want to
belong to the trunk group are connected to the same destination. The following
figure shows ports 2-5 on switch A connected to switch B.
Figure 60 Trunking Example - Physical Connections
2 Configure static trunking - Click Advanced Application > Link Aggregation
> Link Aggregation Setting. In this screen activate trunking group T1 and
select the ports that should belong to this group as shown in the figure below.
Click Apply when you are done.
Figure 61 Trunking Example - Configuration Screen
A
B
example