Chapter 23 Authentication & Accounting
GS2200-48 User’s Guide
201
IEEE 802.1x authentication. The port VLAN settings are fixed and untagged. This
will also set the port’s VID. The following table describes the values you need to
configure. Note that the bolded values in the table are fixed values as defined in
RFC 3580.
23.3 Supported RADIUS Attributes
Remote Authentication Dial-In User Service (RADIUS) attributes are data used to
define specific authentication, and accounting elements in a user profile, which is
stored on the RADIUS server. This section lists the RADIUS attributes supported
by the Switch.
Refer to RFC 2865 for more information about RADIUS attributes used for
authentication. Refer to RFC 2866 and RFC 2869 for RADIUS attributes used for
accounting.
This section lists the attributes used by authentication and accounting functions on
the Switch. In cases where the attribute has a specific format associated with it,
the format is specified.
23.3.1 Attributes Used for Authentication
The following sections list the attributes sent from the Switch to the RADIUS
server when performing authentication.
23.3.1.1 Attributes Used for Authenticating Privilege Access
User-Name
- the format of the User-Name attribute is $enab#$, where # is the privilege
level (1~14)
User-Password
NAS-Identifier
NAS-IP-Address
Table 66 Supported Tunnel Protocol Attribute
FUNCTION ATTRIBUTE
VLAN Assignment Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
VLAN ID
Note: You must also create a VLAN with the specified VID on
the Switch.
