Chapter 4 The Web Configurator
GS2200-48 User’s Guide
46
Bandwidth
Control
This link takes you to screens where you can cap the maximum
bandwidth allowed from specified source(s) to specified destination(s).
Broadcast
Storm Control
This link takes you to a screen to set up broadcast filters.
Mirroring This link takes you to screens where you can copy traffic from one port
or ports to another port in order that you can examine the traffic from
the first port without interference.
Link
Aggregation
This link takes you to screen where you can logically aggregate physical
links to form one logical, higher-bandwidth link.
Port
Authentication
This link takes you to a screen where you can configure IEEE 802.1x port
authentication as well as MAC authentication for clients communicating
via the Switch.
Port Security This link takes you to a screen where you can activate MAC address
learning and set the maximum number of MAC addresses to learn on a
port.
Classifier This link takes you to a screen where you can configure the Switch to
group packets based on the specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to
perform special treatment on the grouped packets.
Queuing
Method
This link takes you to a screen where you can configure queuing with
associated queue weights for each port.
VLAN Stacking This link takes you to a screen where you can activate and configure
VLAN stacking.
Multicast This link takes you to screen where you can configure various multicast
features and create multicast VLANs.
Auth and Acct This link takes you to screens where you can configure authentication
and accounting services via external servers. The external servers can
be either RADIUS (Remote Authentication Dial-In User Service) or
TACACS+ (Terminal Access Controller Access-Control System Plus).
IP Source
Guard
This link takes you to screens where you can configure filtering of
unauthorized DHCP and ARP packets in your network.
Loop Guard This link takes you to a screen where you can configure protection
against network loops that occur on the edge of your network.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A
static route defines how the Switch should forward traffic by configuring
the TCP/IP parameters manually.
RIP This link takes you to a screen where you can configure the RIP (Routing
Information Protocol) direction and versions.
DiffServ This link takes you to screens where you can enable DiffServ, configure
marking rules and set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP
settings.
VRRP This link takes you to screens where you can configure redundant virtual
router for your network.
Management
Table 7 Navigation Panel Links (continued)
LINK DESCRIPTION
