Chapter 7 Basic Setting
GS2200-48 User’s Guide
71
7.6 IP Setup
Use the IP Setup screen to configure the default gateway device, the default
domain name server and add IP domains.
7.6.1 IP Interfaces
The Switch needs an IP address for it to be managed over the network. The
factory default in-band IP address is 192.168.1.1. The subnet mask specifies the
network number portion of an IP address. The factory default subnet mask is
255.255.255.0.
On the Switch, an IP address is not bound to any physical ports. Since each IP
address on the Switch must be in a separate subnet, the configured IP address is
also known as IP interface (or routing domain). In addition, this allows routing
between subnets based on the IP address without additional routers.
You can configure multiple routing domains on the same VLAN as long as the IP
address ranges for the domains do not overlap. To change the IP address of the
Switch in a routing domain, simply add a new routing domain entry with a
different IP address in the same subnet.
Figure 27 Basic Setting > IP Setup
