AEM 3945-B Manual

A SERVICE OF

next previous

Power Quality Analyzer Model 3945-B

53

5.6 Recording Mode

NOTE: After a recording is set, the instrument will go into sleep mode (no display)

to save the batteries. The recording will start as programmed. Press any button

other than the ON/OFF button to turn ON the display again. Turning off the Pow-

erPad

®

clears the schedule, even if turned on again, the recording will not start.

Thismodeenablesalltheparameterspreviouslyconguredinthesetup

mode

toberecorded(see§4.1.8).Presstherecorddisplaymodebutton-

Thevariablefunctionbuttonshavethefollowingfunctionsinthismode:

- Creates a new recording

- Opens a previous recording

- Deletes recording

5.6.1 Saving the Selected Parameters

07/25/02 10:56 100

%

NEW RECORDING

CONFIGURATION : CONFIG 1

START : 07/25/02 10:56

END : 07/25/02 10:57

PERIOD : 1 min

NAME : T E S T

Recording

2

1

Figure 5-19

 Recordingstatusbar(displaysremainingmemorycapacity).

 Parameters - press the

buttons to select the parameters and the

but-

tons to modify them. An underline will appear under the selected parameter.

- Selectthecongurationnumbertobemodiedwiththe buttons.

 (CONFIG1,2,3or4)

- Select the dates with the

buttons.

NOTE: The dates are adjusted according to the chosen recording inte-

gration period. “PERIOD” does not refer to a sampling period, but rather,

toanintegrationperiod(average).