Chapter 7 Wireless
VSG1435-B101 Series User’s Guide
114
7.8 The Others Screen
Use this screen to configure advanced wireless settings. Click Network Settings
> Wireless > Others. The screen appears as shown.
See Section 7.9.2 on page 117 for detailed definitions of the terms listed in this
screen.
Figure 36 Network Settings > Wireless > Others
The following table describes the labels in this screen.
Table 21 Network Settings > Wireless > Others
LABEL DESCRIPTION
RTS/CTS
Threshold
Data with its frame size larger than this value will perform the RTS
(Request To Send)/CTS (Clear To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold
This is the maximum data fragment size that can be sent. Enter a value
between 256 and 2346.
Auto Channel
Timer
If you set the channel to Auto in the Network Settings > Wireless >
General screen, specify the interval in minutes for how often the ZyXEL
Device scans for the best channel. Enter 0 to disable the periodical scan.
Output Power Set the output power of the ZyXEL Device. If there is a high density of
APs in an area, decrease the output power to reduce interference with
other APs. Select one of the following: 20%, 40%, 60%, 80% or
100%.
Beacon
Interval
When a wirelessly networked device sends a beacon, it includes with it a
beacon interval. This specifies the time period before the device sends
the beacon again.
The interval tells receiving devices on the network how long they can wait
in low power mode before waking up to handle the beacon. This value
can be set from20ms to 1000ms. A high value helps save current
consumption of the access point.
