A SERVICE OF

logo

Open as PDF
next previous
3 – Configuring CHAP
Discovery Session—Uni-directional CHAP
SN0054659-00 A 3-3
A
Discovery Session—Uni-directional CHAP
To configure a single-direction CHAP used during a discovery session:
1. Do not enable CHAP on the ISCSI port.
2. Use the initiator add command:
a. Add the initiator that is about to perform the discovery.
b. Enable the CHAP for this initiator.
c. Create a secret (for example, secret_initiator).
d. Use the set chap command to update the initiator’s CHAP settings.
3. Go to the MS Initiator.
4. Click Discovery.
5. Click Add.
6. Type the address of the iSCSI port of the router.
7. Click Advanced.
8. Select Chap Login Information.
9. In Target Secret, type the secret (secret_initiator) you created in Step 2.
10. Click OK.
11. Click OK. The initiator should complete discovery.