4 – Command Reference
Command Syntax
SN0054659-00 A 4-3
A
Admin
Opens and closes an administrator session. You can run any command that
changes the router configuration within an Admin session. Only one Admin
session can be open on the router at any time. An inactive Admin session will time
out after 15 minutes.
When you start an Admin session, the system prompts you to enter a password.
The default password is config.
Authority None
Syntax admin
start (or begin)
end (or stop)
cancel
Keywords start (or begin)
Opens the Admin session.
end (or stop)
Closes the Admin session. The logout, shutdown, and reset commands will
also end an Admin session.
cancel
Terminates an Admin session opened by another user. Use this keyword with
care, because it terminates the Admin session without warning the other user and
without saving pending changes.
Notes Closing a Telnet window during an Admin session does not release the session. In
this case, you must either wait for the Admin session to time out, or use the
admin cancel command.
Examples Opening and closing an Admin session example:
QRouter #> admin start
Password : ******
QRouter(admin) #>
...
QRouter(admin) #> admin end
QRouter #>
