4 – Command Reference
Command Syntax
SN0054659-00 A 4-45
A
Set SNMP
Configures the general simple network management protocol (SNMP) properties,
as well as configuring eight trap destinations.
Authority Admin session
Syntax set snmp
trap_destinations
Keywords trap_destinations
Specifies the setting of the trap destinations.
Examples Set SNMP command example for setting the general properties:
QRouter (admin) #> set snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
Configuring SNMP:
-----------------
Read Community [ ] Public
Trap Community [ ] Private
System Location [ ]
System Contact [ ]
Authentication Traps (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be saved.
Set SNMP command example for configuring an SNMP trap destination:
QRouter (admin) #> set snmp trap_destinations
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
Configuring SNMP Trap Destination 1 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ] 0
IP Address [0.0.0.0 ] 10.0.0.5
Destination Port [0 ] 1024
Trap Version [0 ] 2
Configuring SNMP Trap Destination 2 :
