4 – Command Reference
Command Syntax
SN0054659-00 A 4-7
A
FcipRoute
Configures a new FCIP route and lets you modify or delete an existing FCIP route.
Each FCIP route requires a dedicated FC and Gigabit Ethernet port. Configuring
an FCIP route and specifying an FC and GE port pair take precedence over any
previous configuration for the port pair (FC/GE). This removes the previous
configuration of the port pair.
Authority Admin session.
Syntax fciproute
add
mod
rm
Keywords add
Configures a new FCIP route.
modify
Modifies command modifies an existing FCIP route.
remove
Removes an existing FCIP route.
Examples FCIP route add command example:
QRouter (admin) #> fciproute add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the end
of the list press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE
ports.
Configuring FCIP Route: 1
---------------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
FC Port (1=FC1, 2=FC2, ...) [FC1 ]
GE Port (1=GE1, 2=GE2, ...) [GE1 ]
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [0.0.0.0 ] 0
Selected IPv6 Link Local Address: fe80::2c0:ddff:fe0c:8be2
