Chapter 21 Configuration: Link Aggregation
GS1900 Series User’s Guide
126
The following table describes the labels in this screen.
21.2.4 The LAG Port Screen
Use this screen to view LAG port settings. Click Configuration > Link Aggregation > LAG Port
to open this screen.
Figure 108 Configuration > Link Aggregation > LAG Port
The following table describes the labels in this screen.
Table 89 Configuration > Link Aggregation > LAG Management > Add
LABEL DESCRIPTION
LAG Management
LAG Select the link aggregation group (LAG).
Name Enter the name of this entry.
Type Select Static or LACP.
Member Ports Select the member ports to be part of the LAG.
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.
Table 90 Configuration > Link Aggregation > LAG Port
LABEL DESCRIPTION
LAG Port
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
LAG Displays the LAG index value.
Name Displays the LAG name.
Port Type Displays the port type.
State Displays the state as Enable/Disable.
Speed Displays the speed value as Auto, Auto-10M, Auto-100M, Auto-1000M, Auto-10/
100M, 10M, 100M, or 1000M.
Duplex Displays the duplex value as Full, Half, or Auto.
FlowCtrl State Displays whether flow control is Enable/Disable.
FlowCtrl Status Displays whether flow control is in use (Enable) or not (Disable).
