Chapter 30 Configuration: Management
GS1900 Series User’s Guide
199
Figure 182 Configuration > Management > SNMP > Trap
The following table describes the labels in this screen.
30.3.9 The Trap Destination Screen
Use this screen to view the Trap Destination settings. Click Configuration > Management >
SNMP > Trap Destination to open this screen.
Figure 183 Configuration > Management > SNMP > Trap Destination
Table 164 Configuration > Management > SNMP > Trap
LABEL DESCRIPTION
SNMP Trap
SNMP Authfailure
Trap State
Select the SNMP entity is permitted to generate authentication failure traps. Possible
modes are:
• Enabled: Enable SNMP trap authentication failure.
• Disabled: Disable SNMP trap authentication failure.
SNMP LinkupDown
Trap State
Select the SNMP trap link-up and link-down mode operation. Possible modes are:
• Enabled: Enable SNMP trap link-up and link-down mode operation.
• Disabled: Disable SNMP trap link-up and link-down mode operation.
SNMP Warm-Start
Trap State
Reboot using software or hardware button reboot.
SNMP Cold-Start
Trap State
Reboot though power off.
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.
