Chapter 30 Configuration: Management
GS1900 Series User’s Guide
197
30.3.6 The User Screen
Use this screen to view the User settings. Click Configuration > Management > SNMP > User
to open this screen.
Figure 180 Configuration > Management > SNMP > User
The following table describes the labels in this screen.
30.3.7 The User Add/Modify Screen
Use this screen to configure the User settings. Click Configuration > Management > SNMP >
User > Add/Modify to open this screen.
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.
Table 161 Configuration > Management > SNMP > Group > Add/Modify (continued)
LABEL DESCRIPTION
Table 162 Configuration > Management > SNMP > User
LABEL DESCRIPTION
SNMP User
Add Click Add to create a new SNMP user.
User Name Displays a string identifying the user name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Group Displays a string identifying the group name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Privilege Mode Displays the privilege mode that this entry belongs to.
Authentication
Protocol
Displays the authentication protocol that this entry belongs to. Possible authentication
protocols are:
• None: No authentication protocol.
• MD5: An optional flag to indicate that this user uses MD5 authentication protocol.
• SHA: An optional flag to indicate that this user uses SHA authentication protocol.
The value of the security level cannot be modified if the entry already exists. That means
you must first ensure that the value is set correctly.
Encryption
Protocol
Displays the encryption protocol that this entry belongs to.
Access Right Displays the access mode for this entry. The possible values are Read-Only and Read-
Write.
Action
Delete Click Delete to remove the entry.
