Chapter 13 System Configuration
NetAtlas Workgroup User’s Guide
137
13.5.1 Configuring a Syslog Server
You must specify a syslog server for the switch to send logs. In the Syslog Setup screen, click
Add to create a new syslog server entry or click Modify to edit an existing one.
Figure 94 System Configuration: Syslog Setup: Add
The following table describes the labels in this screen.
Syslog Server Setup
Index This field displays the index number.
Active This field indicates whether the syslog server setting is enabled or not.
IP Address This field displays the IP address of the syslog server.
Log Level This field displays the severity level of the logs which is to be stored on the
syslog server.
Add Click Add to configure a new syslog server.
Modify Click Modify to change the settings of a selected syslog server.
Delete Click Delete to remove the selected syslog server.
Table 59 System Configuration: Syslog Setup (continued)
LABEL DESCRIPTION
Table 60 System Configuration: Syslog Setup: Add
LABEL DESCRIPTION
Active Select Active to enable the settings of the syslog server.
Server Address Enter the IP address of a syslog server in dotted decimal notation.
Log Level Select the severity level of the logs to be stored on the syslog server.
OK Click OK to save the changes and close this screen.
Cancel Click Cancel to discard all changes and close this screen.
Clear Click Clear to start configuring this screen again.
