Chapter 16 Ethernet Port Configuration
NetAtlas Workgroup User’s Guide
167
The following table describes the fields in this screen.
16.5 Port STP
Use the Port STP screen to set multiple/Rapid STP for the selected port(s).
To open the configuration screen, right-click on the switch in the Device List Panel, and click
Configuration > Ethernet Port > Port STP. Then select a device and the port(s) to which
you want to apply this configuration.
Figure 117 Ethernet Port Configuration: Port STP
The following table describes the fields in this screen.
Table 82 Ethernet Port Configuring: Port Link Aggregation
LABEL DESCRIPTION
Group Select the trunk group to which a port belongs.
LACP
Timeout
Timeout is the time interval between the individual port exchanges of LACP packets in
order to check that the peer port in the trunk group is still up. If a port does not
respond after three tries, then it is deemed to be “down” and is removed from the
trunk. Set a short timeout (one second) for busy trunked links to ensure that disabled
ports are removed from the trunk group as soon as possible. Select from 1 second to
30 seconds.
Apply Click Apply to save the changes.
Table 83 Ethernet Port Configuration: Port STP
LABEL DESCRIPTION
RSTP Select this check box to activate Rapid STP (RSTP) on this port.
MRSTP Select this check box to activate Multiple Rapid STP (MRSTP) on this port.
RSTP
