Enclosure network configuration commands 75
Enclosure network configuration commands
ADD OA ADDRESS IPV6
• Command:
ADD OA ADDRESS IPV6 [{<bay number>}| ACTIVE | STANDBY] <ipv6 address/prefix
length>
• Description:
Adds an IPv6 static address for the Onboard Administrator. If IPv6 is enabled, this setting takes effect
immediately. If none of the optional arguments are specified (Onboard Administrator bay number,
ACTIVE, or STANDBY), the command defaults to the active Onboard Administrator.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o The prefix length is mandatory.
o The <ip address> must be in the form ####:####:####:####:####:####:####:####/###,
where each #### ranges from 0 to FFFF. A compressed version of the same IPv6 address is also
supported. The prefix /### ranges from 0 to 128.
o Do not specify a Link Local Address as the IPv6 static address.
ADD OA DNS
• Command:
ADD OA DNS [<bay number>] <ip address>
• Description:
Adds an IP address of a DNS server to the list. DNS servers are used if the system is configured to use
a static IP address. When the Onboard Administrator is configured for both IPv4 and IPv6, the Onboard
Administrator uses the first three valid DNS servers from those configured for the supported network
configuration modes in the following order:
a. Static IPv4
b. Static IPv6
c. DHCPv4
d. DHCPv6
If a bay number is not specified, then the command defaults to the active Onboard Administrator.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
A maximum of two DNS servers can be added.
