Enclosure network configuration commands 94
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
IPv6 addresses cannot specify the network prefix length.
REMOVE SNMP TRAPRECEIVER V3
• Command:
REMOVE SNMP TRAPRECEIVER V3 {<host> [<user name>]}
• Description:
o Removes an existing trap receiver address from the SNMP configuration.
o This command is an extension of the existing REMOVE SNMP TRAPRECEIVER command. If a user
name is specified, all traps matching the host/user name combination are removed. If no user name
is specified, all traps matching the host name are removed.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o The <host> value can be an IPv4 address, an IPv6 address, or a DNS name (maximum of 64
characters).
o IPv6 addresses must be typed without the network prefix length.
REMOVE SNMP USER
• Command:
REMOVE SNMP USER "<username>" [ENGINEID "<engineid>"]
• Description:
Deletes the user specified by the username parameter. If the engineid parameter is not set, all users
with matching username are deleted. Otherwise, users matching the username and engine ID pair are
deleted.
All traps/informs associated with this user are also deleted.
• Access level/Bay level:
OA administrator
• Restrictions:
The engine ID parameter must be a series of hexadecimal characters up to 32 bytes or 64 characters
in length. The engine ID can be prefixed with "0x."
REMOVE TRUSTED HOST
• Command:
REMOVE TRUSTED HOST <ip address>
• Description:
