Chapter 23 Multicast
GS2210 Series User’s Guide
179
23.5.1 MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See Section 23.1 on page 168 for more information on
multicasting.
Figure 128 Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
23.5.2 MLD Snooping-proxy VLAN
Click the VLAN link in the Advanced Application > Multicast > IPv6 Multicast > MLD
Snooping-proxy screen to display the screen as shown. See Section 23.1 on page 168 for more
information on multicasting.
Table 75 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-proxy Use these settings to configure MLD snooping-proxy.
Active Select Active to enable MLD snooping-proxy on the Switch to minimize MLD
control messages and allow better network performance.
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing
MLD messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
