Chapter 23 Multicast
GS2210 Series User’s Guide
185
23.5.5 MLD Snooping-proxy VLAN Filtering Profile
Use this screen to create an MLD filtering profile and set the range of the multicast address(es).
Click the Filtering Profile link in the Advanced Application > Multicast > IPv6 Multicast >
MLD Snooping-proxy > Filtering screen to display the screen as shown.
Figure 132 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Filtering Profile
The following table describes the fields in the above screen.
Table 79 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Profile
LABEL DESCRIPTION
Profile Name
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter
the profile name and specify a different IP multicast address range.
Start Address
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses
that you want to belong to the MLD filtering profile.
End Address
Type the ending multicast IPv6 address for a range of IPv6 addresses that you
want to belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start
Address and End Address fields.
Add
Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Clear
Click Clear to reset the fields to the factory defaults.
Profile Name
This field displays the descriptive name of the profile.
Start Address
This field displays the start of the multicast IPv6 address range.
End Address
This field displays the end of the multicast IPv6 address range.
