Chapter 33 Static Route
GS2210 Series User’s Guide
277
33.2 Static Routing
To enable IPv4 static route, configure the static route settings in the IP Application > Static
Routing > IPv4 Static Route screen.
Click IP Application > Static Routing in the navigation panel to display the screen as shown.
Figure 197 IP Application > Static Routing
33.3 Configuring Static Routing
Click IP Application > Static Routing > IPv4 Static Route in the navigation panel to display the
screen as shown.
Figure 198 IP Application > Static Routing > IPv4 Static Route
The following table describes the related labels you use to create a static route.
Table 130 IP Application > Static Routing > IPv4 Static Route
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
Destination IP
Address
This parameter specifies the IP network address of the final destination.
IP Subnet
Mask
Enter the subnet mask for this destination. Routing is always based on network number. If
you need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host ID.
