Chapter 23 Multicast
GS2210 Series User’s Guide
188
23.6.1 MVR Group Configuration
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to
this multicast group.
Use this screen to configure MVR IP multicast group address(es). Click the Group Configuration
link in the MVR screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
None Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent
or received on this port.
Tagging Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the multicast VLAN ID. Click on an index number to change the
settings.
Active This field displays whether the multicast group is enabled or not.
Name This field displays the descriptive name for this setting.
Mode This field displays the MVR mode.
Source Port This field displays the source port number(s).
Receiver Port This field displays the receiver port number(s).
802.1p This field displays the priority level.
Delete To delete a multicast VLAN(s), select the rule(s) that you want to remove in the Delete
column, then click the Delete button.
Cancel Click Cancel to clear the Delete check boxes.
Table 80 Advanced Application > Multicast > Multicast Setting > MVR (continued)
LABEL DESCRIPTION
