Command Reference Guide BGP Neighbor Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1282
BGP NEIGHBOR CONFIGURATION COMMAND SET
To activate the BGP Neighbor Configuration mode, enter the router bgp-neighbor command at the
Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-list <listname> [in | out] on page 1283
advertisement-interval <seconds> on page 1284
as-path-list <listname> [in | out] on page 1285
ebgp-multihop <hop count> on page 1286
hold-timer <hold time> on page 1287
local-as <as-number> on page 1288
next-hop-self on page 1290
password <password> on page 1291
prefix-list <listname> [in | out] on page 1292
remote-as <as-number> on page 1293
route-map <map-name> [in | out] on page 1294
send-community standard on page 1295
soft-reconfiguration inbound on page 1296
update-source <interface> on page 1297
