Command Reference Guide SHDSL Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 696
test-pattern [clear | insert | 2^15 | show]
Use the test-pattern command to activate the built-in pattern generator and begin sending the selected test
pattern toward the network. This pattern generation can be used to verify a data path when used in
conjunction with an active loopback. Use the no form of this command to cease pattern generation.
Syntax Description
clear Clears the test pattern error count.
insert Inserts an error into the currently active test pattern.
2^15 Generates a pseudorandom test pattern sequence based on a 15-bit shift register.
show Displays the injected error result.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example sends a 2
15
test pattern:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#test-pattern 2^15
