Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 69
clear port-security
Use the clear port-security command to clear the dynamic or sticky secure media access control (MAC)
addresses associated with an interface. This can be done on a per-address or per-port basis. Variations of
this command include the following:
clear port-security dynamic address <address>
clear port-security dynamic interface <interface id>
clear port-security sticky address <address>
clear port-security sticky interface <interface id>
Syntax Description
dynamic Clears the dynamic MAC addresses.
sticky Clears the sticky secure MAC addresses.
address <address> Clears the information for the specified address.
interface <interface id> Clears the information for the specified interface. Type clear port-security sticky
interface ? or clear port-security dynamic interface ? for a complete list of
applicable interfaces.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following command clears all dynamic secure MAC addresses associated with the Ethernet interface
0/1:
>enable
#clear port-security dynamic interface eth 0/1
