A SERVICE OF

logo

Command Reference Guide Frame Relay Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 863
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 3.1 Command was extended to the SHDSL interface.
Release 5.1 Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Usage Examples
The following example enables SNMP on the virtual Frame Relay interface:
(config)#interface frame-relay 1
(config-fr 1)#snmp trap