Command Reference Guide DHCP Pool Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1327
DHCP POOL COMMAND SET
To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration
mode prompt. For example:
>enable
#
configure terminal
(config)#
ip dhcp-server pool MyPool
(config-dhcp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
client-identifier <identifier> on page 1328
client-name <name> on page 1330
default-router <address> <secondary> on page 1331
dns-server <address> <secondary> on page 1332
domain-name <domain> on page 1333
hardware-address <hardware-address> <type> on page 1334
host <address> [<subnet mask> or <prefix length>] on page 1336
lease <days> <hours> <minutes> on page 1337
netbios-name-server <address> <secondary> on page 1338
netbios-node-type <type> on page 1339
network <address> [<subnet mask> or <prefix length>] on page 1340
ntp-server <ip address> on page 1341
option <option value> [ascii | hex | ip] <value> on page 1342
tftp-server <server> on page 1343
timezone-offset <offset> on page 1344
