Command Reference Guide BRI Interface Configuration Command set
61200510L1-35E Copyright © 2005 ADTRAN 566
BRI INTERFACE CONFIGURATION COMMAND SET
To activate the BRI Interface Configuration mode, enter the interface bri command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface bri 1/2
(config-bri 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
bonding commands begin on page 567
caller-id override [always <number> | if-no-cid <number>] on page 573
isdn spid1 <spid> <ldn> on page 574
isdn spid2 <spid> <ldn> on page 575
isdn switch-type [basic-5ess | basic-dms | basic-net3 | basic-ni] on page 576
resource pool-member <pool-name> [<cost>] on page 577
The BRI interface number in the example above is shown as bri 1/2. This number is based
on the interface’s location (slot/port) and could vary depending on the unit’s configuration.
Use the do show interfaces command to determine the appropriate interface number.
