A SERVICE OF

logo

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 262
show monitor session [<session-number> | all]
Use the show monitor session command to display information regarding a specified monitor session or to
display this information for all sessions.
Syntax Description
<session-number> Displays information for a single specific monitor session.
all Shows all sessions.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is a sample from the show monitor session command:
>enable
#show monitor session 1
Monitor Session 1
-----------------
Source Ports:
RX Only: None
TX Only: None
Both: eth 0/2, eth 0/3
Destination Port: eth 0/6