Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 745
fair-queue <threshold>
Use the fair-queue command to enable weighted fair queuing (WFQ) on an interface. Use the no form of
this command to disable WFQ and enable first-in-first-out (FIFO) queueing for an interface. WFQ is
enabled by default for WAN interfaces.
Syntax Description
<threshold>
Optional.
Specifies the maximum number of packets that can be present in each
conversation sub-queue. Packets received for a conversation after this limit is
reached are discarded. Range: 16 to 512.
Default Values
By default, fair-queue is enabled with a threshold of 64 packets.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 5.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Usage Examples
The following example enables WFQ on the interface with a threshold set at 100 packets:
(config)#interface atm 1.1
(config-atm 1.1)#fair-queue 100
