15-8
Save/load of setup data
you can save a set of setup data to a User Box and
load it whenever you want.
All data for 12 items explained above can be saved
to a User Box, to which you can give a desired user
name.
• Saving setup data
1. Select "Save User Setup?" and press the [ENTER/
YES] key.
Now you can select a User Box to which the data is saved.
The first time you enter this menu, "BoxNo1[User1]" is
shown where "1" is flashing, as below. "User1" is the
tentative name.
SETUP
While the display above is shown, you can select a User
Box from among Box numbers 1 through 9 by using the
jog dial (or the [SKIP/CURSOR >>|]/[SKIP/CURSOR |<<]
keys). If you select any of Box numbers 2 through 9,
"--------" is shown in the bracket as below, showing that
the tentative name is not specified.
SETUP
2. Select a desired Box number and press the
[ENTER/YES] key.
The leftmost character of the tentative name flashes,
showing that you can edit the name.
SETUP
3. Enter the desired Box name.
• You can erase the tentative name by pressing the
[MARGIN RESET/CLR] key repeatedly.
• Use the jog dial (or the numeric keys) to enter the
desired characters. A name can be up to 8
characters.
SETUP
Flashing
Flashing
Flashing
Flashing
Flashing
<CAUTION>
When naming a file using PS/2 keyboard, be careful
about the use of special characters. The file name
with the following characters are not correctly rec-
ognized by the Windows OS platform.
“/”, “?”, “.”, “<“, “>“, “|”, “¥”, “-”
Remember that the 1st character of the file name
must start from an alphabet and the following use
only ASCII characters. Although up to 247 num-
bers of characters can be used as a file name, the
maximum number of characters recognized by SDII
and BWF specifications are 23 and 55 respectively.
4. Set the 3-digit number and press the [ENTER/YES]
key.
Set the 3-digit number by rotating the jog dial and/or
using the 10 alphanumeric keys (001~999). The input
3-digit number sets the number attached to the default
file name. The following example sets the default file
name as “DV40-005”.
<Note>
If you enter "000" using the numeric (0) key then
press the
[ENTER/YES]
key, the take number is auto-
matically set to "001".
5. Press the [EXIT/NO] key or [STOP] key.
“DefaultFileName?” appears again. Pressing the [EXIT/NO]
key or [STOP] key goes back to the normal display.
By the above procedures, the default file name is set to
“DV40-005”. If the “TAKE” File Name Mode is selected,
every time a file is newly created, it will be named as
“DV40-5”, “DV40-6”, ......”DV40-9”, “DV40-10”, “DV40-
11”, ......”DV40-111”, ......”DV40-999”.
Flashing
<Example>
• After recording the first take:
• After recording the second take:
• After recording the third take:
HMSF
PGM
LT C
HMSF
PGM
LT C
HMSF
PGM
LT C
SETUP
SETUP
