16-3
Renumbering CUE points
This menu allows renumbering CUE points.
When CUE points are renumbered, CUE points are
numbered in order of time.
This function is useful after deleting a CUE point or
the current CUE points are not stored in order of
time.
You can renumber CUE points of the currently se-
lected file.
1. Select the first level of the "Renumber CUE?" menu,
and press the [ENTER/YES] key.
"Sure?" flashes.
2. Press the [ENTER/YES] key again.
The unit starts renumbering CUE points.
While executing renumbering, "Please Wait!" is shown.
When completed, "RNM Completed!" appears
momentarily and the display returns to the previous
screen before entering the Utility mode.
Flashing
Flashing
Releasing undo files
You can release all undo files of the currently se-
lected file to keep more recording space of the disk.
You can release undo files by file.
1. Select the first level of the "Release Undo File?" menu,
and press the [ENTER/YES] key.
The following warning message scrolls horizontally, while
the remaining space value is shown.
2. Press the [ENTER/YES] key again.
"Release Undo File" appears momentarily followed by
"Completed!", showing that all the undo files have been
released.
<Message>
If you push ENTER key will be unable to undo for cur-
rent file! Are you sure?
3. Press the [EXIT/NO] or [STOP] key to exit the Utility
mode.
The display returns to the previous screen before
entering the Utility mode.
Flashing
MB
REMAIN
MB
REMAIN
