7-4
• Location to the point where the recorder located last time
You can locate to the point between ABS 0 and REC END where the recorder located last time.
1. When the recorder is stopped, press only the [LOCATE] key.
The recorder locates to the point where the recorder located last time.
Note that the [LOCATE] key always holds the time data of the point where the recorder located last time.
• Location to an audio edit point
You can locate to an edit point by pressing the corresponding edit point key ([SOURCE IN],
[SOURCE OUT], [DEST IN], or [DEST OUT] key).
1. When the recorder is stopped, press a desired edit point key.
The display shows the edit point time assigned to the key you pressed.
The display below shows an example when pressing the [SOURCE OUT] key.
HMSFSF
MEMORY
ABS
Flashing
2. Press the [LOCATE] key.
The recorder locates to the edit point and the display returns to the Normal screen.
Tips:
You can edit the time shown on the display after carrying out step 1 above.
By pressing the [LOCATE] key after editing the time, you can locate to the edited time. See "Chapter
6: Storing time data" for details about how to edit time data.
• Location to a CUE point
By specifying a desired CUE point memory (among 01 through 99), you can locate to the
point.
1. When the recorder is stopped, press the [CUE POINT] key.
The display shows a CUE point time with the flashing point number.
2. Use the jog dial to select a desired CUE point memory (between "01" and "99") and press the
[LOCATE] key.
The recorder locates to the CUE point and the display returns to the Normal screen.
If you select a CUE point memory which does not hold time data, "--H--M--S--F--SF" is shown on the
display.
HMSFSF
ABSCUE
Flashing
Tips:
You can edit the time shown on the display after carrying out step 1 above.
By pressing the [LOCATE] key after editing the time, you can locate to the edited time. See "Chapter 6:
Storing time data" for details about how to edit time data.
