4-8
Multiple-undo function
To undo recording, use the multiple-undo function.
YMDHM
S
2
1
-INT-
BWF
FORMAT
CLOCK
-0.1%
kHz
48
24
FS
BIT
DATE
∞
60
50
42 34 28 2018
12
8
6543210OL
2. Select the desired event from the history using the [JOG] dial (or the [SKIP/CURSOR] |<</>>| keys),
and press the [ENTER/YES] key.
After the first take has been completed, if you wish to return to the condition before recording, select
the date/time when the file was created.
"Multi Undo!" appears for a short time on the display, followed by "Undo Completed!", showing that the
undo operation is completed. The display changes to show the beginning of the audio file.
Flashing
<Notes for performing the multiple-undo function>
• You cannot undo recording on a
"Tape mode"
audio file.
• The ending date/time of each take is memorized based on the internal clock, therefore, it is important to
adjust the date/time of the internal clock correctly.
• The unit keeps all takes on the disk in order to make the multiple-undo function for all takes of the current
audio file possible, therefore, the remaining disk space gets smaller each time you record another take.
To release the unnecessary take history (= undo file), use the
“Release Undo File?”
menu in the Utility mode.
See
“Chapter 16: Utility mode”
for details.
1. Press the [UNDO] key.
The display changes to show "Select History?", as below.
The history keeps the date/time when the file was created and the ending date/time of each
recording take.
Tips:
The history of takes starts by the date/time when the file was created, followed by the ending date/time of each
recording take, as illustrated below. By selecting the desired history event and performing the undo function,
you can recall the desired take.
date/time when
the file created
Time
date/time of
take-1 end point
date/time of
take-2 end point
date/time of
take-3 end point
date/time of
take-4 end point
