mesh
OVERVIEW
Redundant PathsCategory:
configPrimary context:
the section called “mesh” (page 569)Related Commands
Usage: [no] mesh [ethernet] PORT-LIST
Description: Congure the specied ports as being members of a mesh group.
A mesh group can have up to 24 member ports.
- VLAN support must be enabled before conguring a mesh group.
- A mesh group cannot exist if IP routing is enabled. Disable
routing protocols (if any) before conguring a mesh group.
- After conguring meshing, it will be necessary to reboot the
switch before the changes take effect.
COMMAND STRUCTURE
■ [no] mesh portlist -- Specify the ports that are to be added to/removed from a mesh. ([ethernet]
PORT-LIST) (p. 376)
EXAMPLES
Example: mesh PORT-LIST
Configure meshing on ports A1-A4, B3, C1, and D1-D3:
ProCurve(cong)# mesh a1-a4, b3, c1, d1-d3
Command will take effect after saving conguration and reboot
ProCurve(cong)# write memory
ProCurve(cong)# boot
Device will be rebooted, do you want to continue [y/n]? y
COMMAND DETAILS
portlist (p. 376)
portlist
■ [no] mesh [ETHERNET] PORT-LIST
Specify the ports that are to be added to/removed from a mesh.
376© 2009 Hewlett-Packard Development Company, L.P.
