connection-rate-filter
OVERVIEW
TroubleshootingCategory:
configPrimary context:
filter (page 185)Related Commands
ip (page 290)
vlan (page 706)
show (page 511)
Usage: connection-rate-lter unblock < host SRC-IP-ADDR | SRC-IP-ADDRESS/MASK >
[no] connection-rate-lter sensitivity <low|medium|high|aggressive>
Description: Re-enables access to a host or set of hosts that has been previously
blocked by the connection rate lter. Disabling or setting sensitivity
may have improved performance after rebooting the switch
COMMAND STRUCTURE
■ connection-rate-filter sensitivity -- Sets the level of filtering required (p. 91)
■ sensitive < low | medium | high | ... > -- (p. 90)
■ connection-rate-filter unblock -- Resets a host previously blocked by the connection rate filter (p.
91)
■ all -- Resets all previously blocked by the connection rate filter (p. 90)
■ host -- Match packets from the specified IP address. (IP-ADDR) (p. 90)
■ src-ip -- Match packets from the specified subnet. (IP-ADDR/MASK-LENGTH) (p. 91)
COMMAND DETAILS
src-ip (p. 91)sensitive (p. 90)all (p. 90)
unblock (p. 91)sensitivity (p. 91)host (p. 90)
all
■ connection-rate-filter unblock all
Resets all previously blocked by the connection rate lter
host
■ connection-rate-filter unblock host IP-ADDR
Match packets from the specied IP address.
sensitive
■ connection-rate-filter sensitivity < low | medium | high | ... >
Supported Values:
■ low -- Sets the level of connection rate filtering to low (most permissive)
■ medium -- Sets the level of connection rate filtering to medium (permissive)
■ high -- Sets the level of connection rate filtering to high (restrictive)
■ aggressive -- Sets the level of connection rate filtering to aggressive (most restrictive)
90© 2009 Hewlett-Packard Development Company, L.P.
