Version Description
8.4.2.0 Introduced on the E-Series TeraScale.
7.7.1.0 Introduced on the E-Series ExaScale.
Related
Commands
ip redirect-list – enables an IP Redirect List.
ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an
interface by entering this command multiple times.
Z9500
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group
name command.
Parameters
redirect-list-
name
Enter the name of a configured redirect list.
Defaults none
Command
Modes
INTERFACE (conf-if-vl-)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
7.4.2.0 Added support for LAG and VLAN interfaces.
7.7.1.0 Introduced on the E-Series ExaScale.
1424
Policy-based Routing (PBR)
