show ip bgp next-hop
View all next hops (using learned routes only) with current reachability and flap status. This command
only displays one path, even if the next hop is reachable by multiple paths.
Z9500
Syntax
show ip bgp [vrf vrf-name] next-hop
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp next-hop command shown in the
following example.
Field Description
Next-hop Displays the next-hop IP address.
Via Displays the IP address and interface used to reach the next
hop.
RefCount Displays the number of BGP routes using this next hop.
Cost Displays the cost associated with using this next hop.
Flaps Displays the number of times the next hop has flapped.
Time Elapsed Displays the time elapsed since the next hop was learned. If
the route is down, this field displays time elapsed since the
route went down.
Border Gateway Protocol
473
