Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
You cannot delete the Null interface. The only configuration command possible in
a Null interface is ip unreachables.
Example
Dell(conf)#interface null 0
Dell(conf-if-nu-0)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
ip unreachables — enables generation of internet control message protocol (ICMP)
unreachable messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
Z9500
Syntax
interface range interface, interface,...
846
Interfaces
