Defaults 100
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
All routers apply the bgp default local-preference command setting within
the AS. To set the local preference for a specific route, use the
set local-
preference command in ROUTE-MAP mode.
Related
Commands
set local-preference — assigns a local preference value for a specific route.
bgp dmzlink-bw
Enables BGP Link Bandwidth.
Z9500
Syntax
bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the no bgp dmzlink-bw command.
Parameters
dmzlink-bw Enter the keyword dmzlink-bw to enable BGP Link
Bandwidth in BGP multipath.
Defaults N/A
Command
Modes
ROUTER BGP
Command
History
Version Description
9.7(0.0) Introduced on the S-Series.
376
Border Gateway Protocol
