redistribute
Redistribute routes into BGP.
Z9500
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map map-name] command.
Parameters
connected Enter the keyword connected to redistribute routes from
physically connected interfaces.
static Enter the keyword static to redistribute manually
configured routes. These routes are treated as incomplete
routes.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
7.4.1.0 Introduced
Usage
Information
If you do not configure the default-metric command in addition to the
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-
originate
command.
560
Border Gateway Protocol
